Instructions

How to Use Your NUWAVE® Sanitizer

Sanitizer

 

CHARGE THE BATTERY

Plug unit into a wall outlet using the supplied power cord and USB charger. The unit will charge until the green light turns off. A full charge may take up to 4 hours. When you see the green light is off, the unit is fully charged. You are ready to use the NUWAVE®.

Connect the NUWAVE

Connect the supplied 1-foot gas flow tube to the to the NUWAVE® ozone generator, then connect to the grey flange fitting of the NUWAVE® Sanitizer chamber.

LOAD YOUR EQUIPMENT

Load all of your personal use items into the NUWAVE® sanitizing chamber and completely close the zipper.

Start Cleaning

Press and hold the “On” button for 2 seconds then release to start cleaning cycle. You should see the blue light illuminate for the next 35 minutes. Leave your personal use items in the chamber for the next 2 hours and remove. You are ready to use your sanitized personal use items.

IMPORTANT NOTE ABOUT CHARGING: If you attempt to charge the unit and you see the green light momentarily flash and then turn off, your unit is fully charged and you DO NOT NEED TO CHARGE THE UNIT. You are ready to use the NUWAVE®.

OZONE NOTE: If you smell any residual ozone, connect your personal use equipment to your machine and run your unit for 30 seconds. This will flush any residual ozone out of your equipment. If you sense that you are sensitive to ozone, discontinue use.

DO NOT USE VINEGAR  to wash your CPAP mask if you are using ozone sanitization for CPAP equipment. Ozone gashave been known to react with vinegar to produce a foul odor on CPAP masks. Use a mild detergent and water if you wash your CPAP mask.

-->

Chin Strap Instructions

Recommendation: Prior to selecting a chin strap, see your CPAP provider and work with your Respiratory Therapist to select the most comfortable chin strap during the initial fitting to ensure proper fit.

CPAP Chin Straps

 

INSTRUCTIONS FOR USE

1. Secure the chinstrap around your head and chin prior to putting on your CPAP mask and headgear.
2. While holding both ends of the straps, position the center of the chinstrap on your chin, then pull both straps around your head until the chinstrap is secure on your chin and around your head. The straps should be positioned in front of your ears.
3. Using your fingertips while holding the straps on the top of your head, fasten the Velcro to the strap to secure in place. You will want a snug fit and may need to repeat this process until your strap fits comfortably around your chin and head.
4. If your model has a support strap, wrap around and fasten the it to the side of your head.

CLEANING INSTRUCTIONS

• Hand wash with mild soap and water once per week.
• Lay on counter top to dry.
• Not made for machine washers or dryers.
• Do not use an iron on product.